If you have a DSC wireless Glassbreak, it is important to keep the battery in good condition to ensure that the device is always working properly. Here is a step-by-step guide on how to replace the battery in your DSC wireless Glassbreak:
-
Open the device: There is a little push tab located on the bottom of the Glassbreak. Use a flathead screwdriver to pry it up and access the battery on the back.
-
Remove the old battery: The battery in the Glassbreak is a CR 123. You may need needle nose pliers to remove it.
-
Install the new battery: Take the new battery and insert the positive side to the positive mark and the negative to the negative. Push the battery into place.
-
Re-attach the cover: The cover should be attached first on the top where the light is. Make sure the cover clips into place.
By following these simple steps, you can easily replace the battery in your DSC wireless Glassbreak and ensure that it is always working properly.